TC burrs - TITANIUM cut
The TITANIUM cut has been especially developed for work on hard titanium materials (tensile strength > 500 N/mm²). It is characterized by an extremely high stock removal rate on this material group, which has very challenging stock removal properties. Tungsten carbide burrs with the TITANIUM cut impress with their smooth milling with considerably reduced vibration and less noise.
Advantages:
- Outstanding stock removal rate and tool life due to the innovative tooth geometry.
- Significantly increased aggressiveness, large chips and very good chip removal.
- Comfortable working with reduced vibration and less noise.
- Reduced wear on the tool drive due to impact-free work without chatter marks, thanks to the high concentricity.
Materials that can be worked:
- Titanium
- Hard titanium alloys
Applications:
- Milling out
- Levelling
- Deburring
- Cutting out holes
- Surface work
- Work on weld seams
Matching tool drives:
- Flexible shaft drive
- Straight grinder
- Robot
- Machine tools
Recommendations for use:
- Determine the rotational speed in each case depending on the titanium alloy you need to machine.
- Reduce the rotational speed if excessive flying sparks occur. Depending on the titanium alloy you are machining, flying sparks may not be entirely avoidable.
- If possible, use the tools on powerful drives with elastically mounted spindles to avoid vibration.
- For the cost-effective use of burrs, work with higher rotational/cutting speeds.
- Power recommendation for tool drives:
- Shank diameter of 3 mm: 75 to 300 watts
- Shank diameter of 6 mm: from 300 watts
- Please observe the rotational speed recommendations.
Safety note:
The very high stock removal rate can cause discolouration on the shank. This does not constitute a safety risk.
